WebSteps. To enable MPxIO for FC drives, run the following command: stmsboot -D fp -e. Reboot the system. To prepare for either enabling or disabling MPxIO on a specific drive port, specify ls -l /dev/cfg/ on the command line. From the output returned, select the port you would like to either enable or disable. Add the port you want to either ... WebThe old Solaris luxadm command still manage FC arrays, but mpathadm command has been developed to work on all the arrays using FC, SAS, and Iscsi connections. mpathadm is included since s10u3 for SPARC and x86 platform with SUNWmpathadm SUNWmpathadmr packages. At this time few patch exist, but many CR are open against mpathadm.
Using Solaris 11.3 with NetApp ONTAP
WebHow to Enable Multipathing. Perform the following steps to enable multipathing on all multipath-capable devices on SPARC or x86 based systems. If you want to enable … WebHow to Enable Multipathing. Perform the following steps to enable multipathing on all multipath-capable devices on SPARC or x86 based systems. If you want to enable … dva switchboard
Solaris configuration and attachment - Hitachi Vantara Knowledge
Multipathing support and property information is identified with the Multipath Management APIplug-in library name. 1. Become an administrator. 2. Identify the multipathing support on your system.# mpathadm list mpath-supportmpath-support: libmpscsi_vhci.so 3. Display the multipathing support properties … See more The following steps describe how to display the properties of an initiator port. 1. Identify the initiator port.# mpathadm list initiator-portInitiator Port: iqn.1986 … See more Display the list of LUNs, along with the properties for each LUNby using the mpathadmcommand. The displayed list of LUNs contain names that … See more Use the steps below to display paths through a target port. 1. Display a list of LUNs.# mpathadm list … See more Display detailed information on multipathed LUNs, including path and target port group information.Note that the name property in the information represents … See more WebThis article will provide an introduction to iSCSI, and will describe how to set up a Solaris 10 host to act as an iSCSI initiator (the endpoint reponsible for initiating iSCSI requests– i.e., the “client”), and a Nevada host to act as an iSCSI target (the endpoint responsible for receiving and processing iSCSI requests from one or more initiators – i.e., the “server”). dust collection for kreg router table